Αποφυγή του (συχνού) καλιμπραρίσματος - DistoX

Εαν τοποθετήσουμε τις μπαταρίες κάπως μακρύτερα από το DistoX μπορούμε να γλυτώσουμε το "βαρετό" & συχνό καλιμπράρισμα της συσκευής:

http://4.bp.blogspot.com/_0b-MGxpLuvE/S ... CF0009.JPG

Hi,



In the club were I’m member from we have 2 distox – A3’s. In the beginning we had the same problem. But bringing the batteries outside the disto via a wire solved the problem.



See photo via the link

http://4.bp.blogspot.com/_0b-MGxpLuvE/S ... CF0009.JPG



Dagobert (Sc-Avalon)






Mazda Motor Logistics Europe NV, Blaasveldstraat 162, B-2830 Willebroek
VAT BE 0406.024.281, RPR Mechelen, ING 310-0092504-52, IBAN : BE64 3100 0925 0452, SWIFT : BBRUBEBB

From: auriga-topo@yahoogroups.com On Behalf Of piezo24sluka
Sent: zaterdag 25 februari 2012 10:06
To: auriga-topo@yahoogroups.com
Subject: Tip for DistoX cells





There are many problems with recalibration after each cell change. There is idea to use "non magnetically" cells as ZnCl primary cells are. These cell have no enough current capacity for laser measurement so only about 100 shots one may do. I tested the DistoX calibration with three sets of ZnCl batteries:

Standard test: four measurements with 90° rotation, one backside, no recalibration between measurements with different sets of batteries.

1. set:

9,7
9,7
9,8
9,7
189,3

2. set:

9,4
9,8
9,7
8,9
189,3

3. set:

9,7
9,7
9,3
9,0
189,1

It was quite cold, so my hands were not rock stabile

Just practical experience:

Don't make shots too fast. Short delay will increase the utilizable capacity of ZnCl batteries.
First sign that batteries are empty is that DistoX will off itself after measurement. One may do several measurements more with longer delay, but not many. DistoX memory will be still OK.